Stonebattle
Senior Member
Last Activity: Today, 03:10 PM
Joined: 10-11-2016
Location: Indianapolis, In
-
My setup has a cage that is 8' 7" high, 12' 6" wide and 7' depth. I have it surrounded by netting, because I did not want balls punching holes... -
I guess Trackman 4 is for indoor or outdoor applications. I have never seen one, but they are selling them.
I have never hit on a GC2 with HMT...Leave a comment:
-
I just found this thread. I can agree with much of what has been observed here. Have any of you taken any data and compared that with the reading you...Leave a comment:
-
I am not an expert either, but I have been looking to get one and how to set it up. You may want to lower the FPS to 40 or perhaps even 30. Shutter speed...Leave a comment:
-
Why is the H cam so much better
I was reading a few threads and it seems the H cam helps a lot. I was wondering if folks here know why. The Protee sensor has an exit row of sensors... -
BackB:
I bought some standard 2 1/2 rubbers tees from ebay and they work fine.
Gene:
I was wondering about that. I like the...Leave a comment:
-
As it turns out I found a sensor in the output row that stayed on when it should have been off during one of Protee's tests. I did the test several times...Leave a comment:
-
It has been sold.Leave a comment:
-
Sorry, it's gone -
Sorry man, it's gone -
I am in the line as well, if you have the backup impact screen. Thank you -
If grant doesn't buy it I would like.
thanks coz -
Impact screen for sale
Well, I was getting ready to put my new screen up and things have come up. It is from DBgolf72 direct from the factory and it is a great screen. It's... -
If you are not into adjustments, I'm not sure how Protee would work out. Also, I've only had my unit a short time, but I'm not sure you would be satisfied...Leave a comment:
-
Bubba:
Interesting you put me onto that page. I must have done the tests shown on the page at least 5 times before. I did the tests again and...Leave a comment:
-
Setup and Club data
I bought a used P3proswing from a forum member for my son a few weeks ago. As it turns out the Protee sensor; I also bought from from a forum member,...Last edited by Stonebattle; 02-15-2019, 02:21 AM. -
Whoops, I think the last face to path data point is wrong, it should be 8 degrees.Leave a comment:
-
Hmmm, yes I have the same observation. I would have to say based on the video one only has to be close, although setup is often the accused when misreads...Leave a comment:
-
The video says directly over the sensor. It does not stipulate exactly where that is, but the center is just behind the hitting area. It does look like...Leave a comment:
-
Thanks Bubba
I have gone through the page you recommended line by line in order to make sure my sensor was working correctly. I could not find...Leave a comment:
No activity results to display
Leave a comment: