So, I got the E6 Connect demo last night, and have been playing around with it. I like it, especially all of the camera panning, but it seems to jutter an awful lot. I'm trying to figure out if it is something in my setup or if it is inherent to my software?
The jutter I'm describing is that every time the camera pans, it isn't butter smooth like it should be. My PC is overbuilt as hell for sim golf, I have an overclocked and watercooled i9-9900k processor and an overclocked Asus ROG Strix RTX 2080Ti, so it isn't my PC. My projector is a BenQ LK 953ST, which runs 4k 60hz but due to HDMI limitations in my current setup it's limited to 4k 30hz. I'm going to try a direct active cable rather than the two cables I have joined by a booster to see if that helps, I just was wondering if I'm the only person who noticed it?
The jutter I'm describing is that every time the camera pans, it isn't butter smooth like it should be. My PC is overbuilt as hell for sim golf, I have an overclocked and watercooled i9-9900k processor and an overclocked Asus ROG Strix RTX 2080Ti, so it isn't my PC. My projector is a BenQ LK 953ST, which runs 4k 60hz but due to HDMI limitations in my current setup it's limited to 4k 30hz. I'm going to try a direct active cable rather than the two cables I have joined by a booster to see if that helps, I just was wondering if I'm the only person who noticed it?