I replaced the GC2 with an updated version. But I am having issues getting the incoming port set to Comm 3. Does anyone know if the old machine would cause connections issues. It finds Comm 6 but I am unable to change it to comm 3. The computer does find the new GC2 and sets the outgoing to comm 4 but I am unable to set the incoming port. I have Windows 11 and most of the instructions are for Windows 10 so there is some confusion with the settings. I am having trouble deleting the old GC2 from the computer but the new one shows up but will not connect. Any help would be appreciated.
- Golf Simulator Forum is the center point for discussion on golf simulator products, brands, manufacturers, launch monitors and everything else related to golf simulation.
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.