Tweet
I recently built my indoor simulator using the Garmin R10, E6 connect, and an Ipad all connected to a projector. My issue is when I open E6 connect and try to use the range or golf course, the course/range does not show. The screen is black or static but it shows metrics at the top along with the mini map. The system still tracks the ball and registers the Garmin R10. When I use just the Ipad, the same image issue occurs. I feel like this is an issue with the Ipad or E6 connect but E6 support was not helpful. Any thoughts or suggestions would be greatly appreciated.
- Golf Simulator Forum is the center point for discussion on golf simulator products, brands, manufacturers, launch monitors and everything else related to golf simulation.
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.