Good morning guys looking for some advice. My skytrak is a week old. I went out to practice with it and noticed it was not recording any shots. I closed out the st app on my pc. Shut off the monitor reopened the app and turned skytrak back on. It is connected through usb. It did not connect rather just stayed in discovering mode. I tried to direct connect it without it plugged in and it connected but gave me a critical battery alert. I then tried to charge it and the amber light shut off after 2 minutes indicating a full charge. I reconnected in direct mode and it didn’t give me the critical error however and when I went into practice mode it would not register the shots. I’m running the latest firmware and software. I tried various usb cables with no success. Now it did take a soft hit from a shanked chip shot from my nephew last weekend. It did not knock it over as I made a wooden box for it till I bought the protective case. But after that incident it worked fine until yesterday. I played multiple rounds and driving range time with it with no issues. Any suggestions before I get on the phone with skytrak today?
- Golf Simulator Forum is the center point for discussion on golf simulator products, brands, manufacturers, launch monitors and everything else related to golf simulation.
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.