The shaft lean itself probably wont be the shaft lean over the front row, it could however raise the clubspeed a little.
the side spin will be from...
Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
Each camera use 500ma.
with these cameras, it either works or doenst so I doubt it's the cameras....
Leave a comment:
-
You wouldn't need support to fix the same issue each time if the issue was fixed correctly on full.
split screen camera images is usually power...
Leave a comment:
-
What you have to understand here is that without seeing the set up it is hard to find a suitable fix for you.
I've offered remote support to have...
Leave a comment:
-
I already did answer. The front row is for ball speed not clubspeed.
impact and back row deal with clubsoeed into the ball.
With excessive...
Leave a comment:
-
Splice screen cameras is a power issue and not camera.
split screen is when the cameras cant boot properly.
usually clicking preview reboots...
Leave a comment:
-
Powered hubs are absolutely fine.
If it is something that is happening more recently then it could be pc set up as windows can change certain settings...
-
The issue here if cans are split screen is power related. Either they are going to sleep, which if you have to preview to make them run reboots them....
-
If the cameras go split screen then it's a power issue or they are going to sleep.
this can be fixed by making sure one camera is plugged in the...
Leave a comment:
-
Tbe high spin correction alters the physics a little to suit ball reaction on the green for some they may say it spins too much and some not enough. It...
Leave a comment:
-
You could possibly increase speed readings with excessive shaft lean as it could trigger sensors earlier but speeds would be higher and not lower as you...
Leave a comment:
-
In TGC start up menu, go to settings tab and change High spin correction from on to off.
You can also change default green speeds here also...
Leave a comment:
-
Clubspeed could be affected and show lower if the strike is a bit heavy as it is speed through impact. The system detects heavier hit strikes through...
Leave a comment:
-
The clubspeed is a direct measurement from the sensor mat.
Ball speed is a direct measurement from the sensor mat
The speeds are not...
Leave a comment:
-
Runnrebel,
can you email me jamie@proteeuk.co.uk.
If you have a new system, you have support to ask any questions or for help. This is the...
Leave a comment:
-
No need to do a reinstall again.
club speed is measured so it depends what it compared against, club speeds between any units fluctuate a...
Leave a comment:
-
If you would like me remote in and have a good look feel free to email me. If you feel that the 90 is correct then change the setting on minimum chipping...
Leave a comment:
-
Stone battle I notice on the images that the 2 at 90 yards ish are probably not correct. The new routine used actually kicked in on the one that carried...
Leave a comment:
-
It is often easier to email me to discuss things like this as dont always have time to reply promptly here
Leave a comment:
-
Hi Sronebattle,
Firstly did to completely remove the old interface including all folders as per the instructions? If you simply installed...
Leave a comment:
No activity results to display
Show More
Leave a comment: