New firmware update for Mevo+ (Version 0.13)

[Knickerbocker]

I have not tried it yet. I was planning on firing it up tonight.

[Bubba22]

Anyone try DSP 1.6? Is putting better?

[Shankz]

I think your going to have to call them and ask them to put you on it. I am on it for one of two reasons,
1. I bought my mevo+ from Flightscope or
2. I emailed and called enough times so have me on speed dial.

[Noob20]

I don’t get emails, how do I start receiving them?

[Shankz]

I am a little confused also, this is the email I got today around noon. The update was already out and then the email shows and it says that 0.16 will be released soon. I guess the email should have come out a few days ago.

[Noob20]

Noob20 DSP is the firmware version

Mine is 0.16. Didn’t know they were onto 0.16 yet.

[JayJo13]

Noob20 DSP is the firmware version

[Noob20]

Is it possible it’s version .16 now? How do I tell which version I have now? I think I downloaded the latest just now, but don’t see anything that actually says firmware. It says AVR version and DSP version. App version is 3.3.0

[motts]

Are there any release notes for 0.15? I didn't get an email for this one

[JayJo13]

I'm still running 0.12 as well. I think I'll wait and hear what other people are saying before I update

[Shankz]

Think I will wait to download this one.

[Knickerbocker]

Version 0.15 was released this morning. I haven't downloaded. I am still running 0.12.

[Noob20]

I've never been able to get roll completely at 0, but I'll try putting from 4.5' in front of the Mevo. I've never tried anything that close. Thanks for the tips.

[JayJo13]

Everybody seems to have different levels of success with different environments. Personally, my setup works very well with the exception of short chip mis-reads and no-reads from time-to-time. Putting works very well for me.

I have 10.5 feet from tee to screen and 8 feet from tee to Mevo+. I putt about 4.5 feet directly in front of the Mevo+ and have roll at 0.0 and tilt at 11-degrees.

[Noob20]

I had thought I did that, but probably didnt. I think the firmware update process is not as straightforward as it could be, since you can only do it with an iPhone/iPad and the wifi has to be hooked to the unit.

I'll try again. Assuming I am able to get the version 0.14 installed, I have the unit 7' for putting and the surface is flat. Are people better off putting to the right or left of the normal hitting surface? Unit is at 12 degrees?