Mevo+ E6 Connect PC not reading any shots at all

[jimmyd]

I recently updated to DSP version 0.16 and then updated E6 to 1.5.1.1. After playing 3-4 holes E6 crashed. After starting it up again it will not read any shots at all. I have contacted both FS and E6 and am awaiting a response but I thought I would reach out to see if anyone else has had this problem.

More info:

• I have had the simulator setup since November and have been very pleased with full shots. I rarely had a misread. (Putting has bee somewhat of a challenge but I am ok with that.)
• FS golf app currently works great. I have had 0 misreads and have been using this on my Android phone while E6 PC is not working
• According to E6 the Mevo+ is connected. I can align the camera just fine through E6 and I can initiate a Calibration from E6.
• The connection status light is green on the Mevo+
• The Mevo+ appears to ready to measure as the radar light is solid red for "Armed, ready to measure" as it did before when it was working.
• When I initiate a calibration from E6 the radar status light turns green and then back to red/armed as it did before when it was working.
• I have been using 2 WiFi adapters so that I can connect to the internet and the Mevo+ at the same time.

I am going to borrow an IPad and load E6 IOS version to see if that works. Perhaps I can narrow it down to my PC or E6 PC version. Does anyone have suggestions or have had this happen to them?

[jimmyd]

Update, I tried E6 from my iPad and it worked great. It looks like an issue with E6 PC version or a setting on my PC. I tried disabling my firewall, reinstalling E6, and connecting with both WiFi adapters to no avail. Next step is reverting windows to an earlier time. Perhaps a windows/ driver update is the culprit.
Any other ideas?

[jimmyd]

The issue seems to be resolved. I reinstalled windows and wiped all of the files. Then reinstalled e6 1.5.1.1.