TGC2019 with Mevo+

[arwin]

I got my ST license transferred over to my Mevo+ for TGC.

In the FS Golf App, there's that setting for the height discrepancy from where the Mevo+ sits and the hitting surface.

But in TGC2019, that setting isn't there. When I was using my ST, it constantly had my 7i at 22*
I'm noticing that with the Mevo+, my max launch angle with the 7i is now 16*...but usually somewhere between 13-16*.

Do I need to have the Mevo+ on the same level as the hitting mat?
I can extend some pieces of wood to make it the same level but then the mevo wouldn't be at the same level as my putting matt now since it's pretty thin.

[JakeGeezy]

Ideally yes, the m+ needs to be on the same level for everything. It uses the floor to calculate launch angle.

[arwin]

There's no setting in TGC to account for this?
I've also noticed that no matter what I do, the putting in TGC is off with my M+

I tried setting it on the floor and it's basically level with the putting mat and I will smash a putt (Feels like at least 50 ft) and it only reads as 6 MPH.
Same thing when I make a plank to set it level with the hitting mat but the putting mat is lower.

[JakeGeezy]

It sounds like you have interference with the m+. It's picking up on other things moving in the room. Call FS support. Also, make sure you're on firmware 12. It has the best results for most people.

[arwin]

You think it could be interference?
I was using the FS Golf App with my ipad in the same environment and it was reading everything flawlessly

I've re-arranged my environment now to make everything level.
But now I'm having other issues before I can even test the putting again.

I'm connected to the M+ Wifi with my 2nd wifi adapter but when I launch the TGC FS Interface, TGC says it can't find a device.

Also, last time I noticed that the M+ went into standby mode while I was in TGC...I couldn't figure out how to wake it up again.
It seems like it lost connection and then it took multiple re-boots of my cpu and the M+ to get the TGC FS interface to find the M+

[arwin]

After another reboot and connecting to my m+ wifi, I was able to get into TGC.

Launch angles are much better now that I made everything flush. Had to move everything around and then layer plywood and stuff to get the right height.

What a pain. But I hope this will be a great setup for the long term