I’ve tried to get new FS Golf to work but it never “arms” the Mevo+. The red light never comes on. E6 and FS Skills both work but not FS Golf. I have deleted and re-installed the app, tried to disable “auto-join” on all other networks but still no luck. Emailed Flightscope support so will see what they suggest. Has anyone else seen this?
-
-
How old is your unit?
I have a relatively early serial and after the 3.8.x release for the Pro package, I think they force re-registration and with that, my unit lacked certain info (or they lacked it on their side), so while it looked like it registered something was amuck to cause the app to not arm the radar. E6 and Skills worked fine.
This caused a no-arm condition for me with the following release along with 4.0.
I strongly suggest calling and not emailing, their email support for things like this leaves a lot to be desired. My email case went no where until I called in.
Once the did that, the person I worked with was able to confirm/deduce the registration problem on their side and it required a level 2 support person to get on a remote session with me to get into my unit on the wifi and grab whatever low level data they needed from it (note: this requires a computer with 2 network connections, one wifi to mevo another either RJ45 ethernet or a second wifi interface). That did the trick and I was back to working a day ago.
Good luck.
-
Turns out that message I have been ignoring about registering my Mevo was a little important…. I had to register it and then it worked. To register with only one wifi connection, I had to connect to the Mevo and click register, once you fill in the information, before you hit next, you have to connect to wifi then hit next. When that is done, then connect back up to the Mevo and complete the process. Reboot the Mevo and re-start the app. Voila, it worked. Thanks for your help.
-
Comment