Fr1 software won’t work properly on gc2

[bath4golf]

any help would be greatly appreciated..... I can’t get fr1 software to work with my gc2. It initially registeres and shows shot for 3 seconds and then stops and shows the ball back at starting place or even rolling backwards.....

[DannyMRICS]

I had something similar. Is your launch angle showing as zero on FR1 even though the GC2 is reading it correctly?

Stingreye sent me an update, which I’ve tried to pm to you. Hope that works.

Danny

[Stingreye]

What Danny said, update to 1.30 (I think that’s the foresight components version number you need). If it’s still off make sure you run the sim setup tool where you tell it yourbsim room dimensions sometimes that fixes odd behavior in fr1.

[bath4golf]

Thanks so much. Worked perfectly! Now I just have to figure out how to offset my center line to the right

[Stingreye]

The golf sim setup or something similar program with fr1. Tell it where your gc2 is located in your room and your tracer will start on the screen where it hits it.

[eyegolfNE]

Could you send that update to me too? I’d be very appreciative

[DannyMRICS]

Could you send that update to me too? I’d be very appreciative

PM’d you.

Dan

[bath4golf]

finally got setup correct and all works well and offset is good too. Thanks for all your help

[PlayingGolfish]

Hello! Does anyone have the firmware mentioned above and can send it to me? I am currently experiencing the same problem with my GC2 and FR1 software. Thank you so much!!!