gc2 putting

[thedancerjin]

i have protee 2.0 sensor and gc2. but i didnt use protee 2.0. im using gc2 only.

i heard gc2's accuracy is good. so i bought GC2 even i already have protee 2.0 sensor.

and i have skytrak too.

but i think GC2's accuracy isnt good especially too much draw spin and putting..

when i play TGC.. my 70% shot goes to left..even i hit straight shot or fade shot.

and when i do putting.. ball goes to wrong direction. even i hit straight shot.. i can see '1.2R.. 3.1L...1.9R.. sometimes 9.1L...;'

i wonder how can enjoy putting with GC2? i set forgiveness to '3'. but it wasnt fix my problem..

im thinking to sell GC2 and i just enjoy TGC with protee sensor and enjoy Skytrak with WGT.. i cant believe GC2's number..

how about your GC2?..

im korean. my english is really bad.. please understand..

[Bubba22]

Any GC2 users care to comment or offer some advice in setup!

[bubs3141]

you need to align your GC2 better. I can put straight with the GSX putting set at 2.0. Make sure your GSX settings are correct. Also make sure your GC2 is aligned straight to your hitting line.

[Ronsc1985]

Do you have the latest GC2 Firmware 3.7.0.0 installed? If not it is available on the Foresight web site.

Another possibility is you do not have the GC2 lenses pointed exactly 90 degrees to your intended line of ball launch. It is mildly difficult to align the GC2 properly because the case is angled and thus you cannot use the long side case edge as your reference. The front edge is better. If you have this parallel to your intended line of launch AND the cameras have not been knocked out of alignment the azimuth measurement is within the unit spec i.e. +/- 1 degree. I have measured the angle of departure many times and it is always spot on.

Your English is a hell of a lot better then my Korean. In fact after being out of Korea for 50 years I hardly remember a word although I didn't learn that many to begin with.

[mthunt]

When I had the GC2 on current firmware and the older version of GSX and TGC, I found things not accurate. The drives went too far and the ball moved way too much. A 500 spin draw would draw 30 yards or more. I now use the recommended firmware in the setup section. I find it really accurate. For putting and hitting, the thing needs to be aligned. Use the flat putting green in TGC and hit putts. You'll get it lined up then try.