Tweet
I recently acquired an older full swing simulator. It’s the one with the 2 360° strips between the tee and screen. Everything works as it should except the IR sensors do not pick up the golf ball when it’s hit. The sensors have the correct power to them, however, it came with the Ethernet like cables unplugged and I cannot figure out the proper sequence which they plug in. Anyone have any experience in this?
- Golf Simulator Forum is the center point for discussion on golf simulator products, brands, manufacturers, launch monitors and everything else related to golf simulation.
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
Comment