Tweet
Since installing the divot action strip in a cutout of my 5 by 10 foot mat I have noticed that I have more shots that don’t get picked up by skytrak. I have the skytrak at the same elevation and it is level. I’m not sure if the give in the divot action strip causes the skytrak to not read the shot? Also, my divot action strip is tight inside the cutout but after 10-20 shots I can see the corners popping out and have to continually reset the divot action strip. The four corners have a foam piece that extends out about a half inch but I find that after 10-20 shots I can see the foam corner? Has anyone else experienced this?
- Golf Simulator Forum is the center point for discussion on golf simulator products, brands, manufacturers, launch monitors and everything else related to golf simulation.
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.