-
I ordered the screen from Heavy Duty Tarps (https://www.heavydutytarps.ca/) and they customized it for me. I elected to go without grommets and I use tarp clips instead. That way I have the option to move them around a bit if I want to or if some areas are showing wear. I also had them sew a 3" sleeve along the top and bottom so I could just slide 1" EMT through. This was also way cheaper than ordering a stock screen. -
On the screen order what did you use from grommet spacing? Also did you have to ask for the edge condition that allowed you to place the bar or was that standard? -
Thank you!
The bounce back is a little more than I hoped for but it's still reasonable. Probably bounces off the screen about 3-4 feet with a driver. I think if I put some foam underlay underneath the collection area mat it will be fine. I could also hang something behind the screen that would help. It's definitely not bad enough right now for me to want to do anything about it. -
That is a great set up sir!!! Very well done!!!!
Quick question, how is the bounce back of the golf balls? By the way, I am so jealous!!Leave a comment:
-
I inserted a 10' length of 1" EMT conduit in the bottom sleeve and then wrapped some 1" pipe insulation around the bottom sleeve & EMT. It's definitely heavy enough to give the screen a good vertical stretch. -
Not sure what happened to the photos in my original post so I've posted them here.Leave a comment:
-
Really good looking finished job and great breakdown of all your material thank you!Leave a comment:
- Golf Simulator Forum is the center point for discussion on golf simulator products, brands, manufacturers, launch monitors and everything else related to golf simulation.
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
Leave a comment: