Bottom Part of Screen is Not Attached - How to Prevent Balls Under Screen?

[TheDon07]

My build does not use any bungees for the screen. I have the screen wrapped over the side and top poles and pole clamps to hold it in place. I do not have anything holding the bottom of the screen and some putts and bladed shots cause the ball to go under the screen. I would like to get some suggestions to keep a clean look, but also stop the balls. I appreciate the help!

[3on3putt]

I don't have a picture handy but I bought two large pool noodles at Walmart (the jumbo size ones) and wrapped them over the top of my bottom enclosure bar. Then I wrapped my floor turf around the pool noodles to create a little "speed bump." It blocks all balls and you don't see any of the pool noodles because they are covered by the turf.

[preludesam]

I think I am going to use this. Found it in another thread.

https://golfsimulatorforum.com/forum/golf-simulator-forum/simulator-builds/298905-padding-for-worm-burners-what-are-my-options

https://foamonline.com/wedge/

[mwh1023]

Spectrum golf has this 10’ wedge pad for the bottom of the screen buts a little pricey at $80.00.