I have seen a couple of pictures of people's builds where the sensor and the floor are totally level. I currently am standing on a box I built to be level, but it's awkward and makes it hard to swing freely. Are there plans anywhere in how best to build out my floor to be level with the pad?
Building out the floor for sensors
Collapse
X
-
Tags: None
-
I had plenty of ceiling height to work with so I just built a full 2x4s frame over the original floor. You can strip down the 2x4s if needed to get a lower framing. I don't know of any plans available I just did a layout of what I wanted and went from there. This was my first setup.2 Photos
Comment