A fiend while teeing up seems to have pushed my tee holder out of position so it is much lower than it was originally. I am having trouble pulling it up to its original height. Is there any trick that anyone knows to get it back up to its original height? I have to use outrageously long tees to get a ball to a good height.
-
-
Needle nose pliers should work.
I use the shortest tee holder possible. It actually sits on the ground and only protrudes about a 1/4 inch above the sensors fiberbuilt base, well below the grass level. I use 3 different 4moreyards tees. See tees section. -
If you look at the bottom side of your protee sensor you can see how the rubber tee can be pushed further to the ground. I ended up placing a gatorade bottle cap underneath the rubber tee...thus not allowing the tee room to move.. Now my rubber tee has support underneath so it no longer can be pushed down by accident.Comment
-
I ended up cutting an almostgolf ball down to size and put it under the tee to prevent it from slipping downComment
-
be gentle with the needle nose pliers; in a careless moment I tore a part of my tee holder last year when getting it back outComment
Comment