Wired or wireless?

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Jeff Tilley
    Senior Member
    • Jan 2017
    • 109

    #1

    Wired or wireless?

    Skytrak should be in soon, getting ready to start the build. My setup is gonna be in the garage. I do have wi-fi, but have slowdowns with it when the kids are over and all have their iPhones out. In you guys opinions, would I be better served to get a wi-fi extender or an ethernet cable? Pros and cons please................
  • awisnia
    Senior Member
    • Jan 2016
    • 236

    #2
    Lots of information to be found with some searching.

    Need more information to help; Will you have a pc? iPad? Sim software? Just hitting range?

    I have PC with SkyTrak and play TGC

    I would suggest wired ethernet to the pc and wifi direct between the pc and skytrak. (skytrak will show as an access point to the pc)

    Here's a thread I started last fall
    I've seen bits and pieces around the forum, but haven't found a firm position. My sim is set up and I have little cause to take my ST anywhere other than my

    Comment


    • pkim813
      pkim813 commented
      Editing a comment
      Has anyone reported using those Powerlink/powerline wifi adapters as "hardwiring" for PC-sim setups? Uses the electrical wiring in the home to extend the internet into whichever room. Plugs into ethernet of your PC. There is always loss of efficiency but better than true wifi. ?

    • dipfam7
      dipfam7 commented
      Editing a comment
      My PC is connected via ethernet. Been using my skytrak in USB mode. When trying to connect wirelessly, I can't seem to discover the Skytrak, even as an access point. Any tips?
  • Lgnir
    Senior Member
    • Jan 2017
    • 248

    #3
    I have my setup in my attached garage as well. I'll be honest, my opinion is, why not use the SkyTrak hard wired to my laptop through a USB cable? Logically, I figure I am removing one thing (connecting by Wi-Fi) that could possibly have an issue. My laptop connects to my house Wi-Fi, and I have had no issue with using the SkyTrak software or TGC. I even bought a 10' USB cable to ensure I had enough slack if I want to move my laptop stand further away from my SkyTrak.

    Comment


    • DirtyGarry24
      DirtyGarry24 commented
      Editing a comment
      Hey Lgnir, if the USB route works for you, then I'd say stick with it. However, many people (myself included) have seen that wifi really cuts down on the no-reads. It really doesn't make sense, but it sure works this way for me. I would have 4 - 5 no reads a round in TGC when I was using USB. I play multiple rounds with zero no reads after going to wifi.

      The cons of wifi are loss in connectivity occasionally and having to be diligent on charging the ST battery.

    • Lgnir
      Lgnir commented
      Editing a comment
      Interesting...couldn't you solve the battery issue by just having the ST plugged in to charge, or will it not work in network mode if it's "plugged in"?
  • Jeff Tilley
    Senior Member
    • Jan 2017
    • 109

    #4
    Originally posted by Jeff Tilley View Post
    Skytrak should be in soon, getting ready to start the build. My setup is gonna be in the garage. I do have wi-fi, but have slowdowns with it when the kids are over and all have their iPhones out. In you guys opinions, would I be better served to get a wi-fi extender or an ethernet cable? Pros and cons please................
    Sorry, forgot to mention this will be with a laptop and will go with JNPG later. Probably looking at going ethernet since my wi-fi gets loaded down AND my signal will be weaker in the garage. Anybody got a wiring diagram that tells me how to hard wire everything and what cables to use? My modem and router are in the living room roughly 20 feet from where my hitting area will be. I have no problem running the wiring thru the attic.Would like to buy the right stuff the first time if ya know what I mean............

    Comment


    • awisnia
      awisnia commented
      Editing a comment
      Easiest just to buy an ethernet cable with a plug at each end if you're only doing this once - tape over the plugs while pulling it through the attic. Plug it into the router, and into the notebook. You can buy them many places. for example https://www.walmart.com/ip/Fosmon-10...-Blue/41381337

      It seems counter-intuitive, but wifi direct between the SkyTrak and PC works better than USB. Some have suggested it's because of the power-saving schemes that may cycle the usb port off. Don't really know, but I no longer hang up in TGC or stop reading shots - just works. I have the SkyTrak usually plugged into a charger 99% the time.
  • Jeff Tilley
    Senior Member
    • Jan 2017
    • 109

    #5
    Originally posted by Jeff Tilley View Post

    Sorry, forgot to mention this will be with a laptop and will go with JNPG later. Probably looking at going ethernet since my wi-fi gets loaded down AND my signal will be weaker in the garage. Anybody got a wiring diagram that tells me how to hard wire everything and what cables to use? My modem and router are in the living room roughly 20 feet from where my hitting area will be. I have no problem running the wiring thru the attic.Would like to buy the right stuff the first time if ya know what I mean............
    What do you use between your PC and projector? HDMI, VGA, etc. ?

    Comment

    • Jeff Tilley
      Senior Member
      • Jan 2017
      • 109

      #6
      Update-built a new shop behind the house, hitting bay all set with Creative Golf 3D, and full strength internet using MOCA adapters at each end of a cable run underground from the house to the shop. Not wireless in the shop, just Ethernet cable from the MOCA to my laptop. Using HDMI with a splitter to BOTH projectors, a short throw for the sim and a long throw for movies, sports, etc.......

      Comment

      Working...