Sky Track and White Iron Shafts

[RTonkin]

I just got a new set of clubs with white shafts. I cannot get the SkyTrak to read my shots. I know there was an issue with white driver heads that was resolved by hitting an inch behind the red dot. Having tried that, I am getting shot reads on long and mid irons. I assume the higher lofted clubs are getting above the camera area when I hit behind the dot. Do I need to start looking for a GC2 or does anyone have anything to try?

[SFR]

A GC2 won't be any better. Anything white can create issues as well as white headed clubs. May not always happen but will the odd time with the GC2 reading a massive pull read on the off line.

Best may be to wrap some black tape around the shaft at least a foot or so up from the club head. Use one that will remove easily without a residue issue, like electrical tape.

[jut111]

Try using a yellow ball? It's not technically supported, but I use yellow chromesofts all the time and it reads fine.

[apljb]

I had the same issue almost a couple of years ago with white shafts - if you search, you'll probably find the old thread.

As suggested above, you can put some black electrical tape on the front of the shafts, if you find my original thread, you'll see a picture of my shafts and where the tape was that I put on originally.

I discovered that I didn't need the tape, just needed to move the ball behind (to the right of the laser dot) far enough that the ball got into the camera view before the shaft did. Your distance to move it may vary, but I found that 2-3 inches was adequate - I never had problems again after that with my white shafts.

HTH.

[Frank Castle]

Has anyone had issues using m1 driver?
im getting bad reads mostly high right and short

[KerrHughes]

I use this years M2 which is the same colour and don't have any issues. I use my SkyTrak at the range and the flights are near identical.

[dvillicana]

Im having the same issue with my M1 driver. Every shot is also high right and very short. Rest of the clubs are spot on. Not sure what to do.

[Frank Castle]

I use aero burner 3 wood on tee because of m1 readings it is also white but readings are good