I’ve seen this addressed before, but have yet to see a solution I think looks good. I have the DIY enclosure with 1 inch emt. I’m looking for some suggestions on ways to cover the gap between the clips holding he screen and the emt. Both so balls don’t go through and also so it just looks cleaner. Pictures appreciated too! Thank you
- Golf Simulator Forum is the center point for discussion on golf simulator products, brands, manufacturers, launch monitors and everything else related to golf simulation.
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
Comment