One big question as I am finishing my build this week, I am laying the Synlawn putting green over the whole platform, how do you recommend to cut the slits in the green for the sensors for the putter sensor and keep the edges clean?? Thank you in advance!
- Golf Simulator Forum is the center point for discussion on golf simulator products, brands, manufacturers, launch monitors and everything else related to golf simulation.
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
Comment