Edging for putting surfaces

[Parsaver]

What have you guys used for edging around your indoor putting greens?

I've seen some pictures of ones with no edging and the turf folded under the substrate. Im12 feet wide and that is exactly the width of the roll from TFD. I don't want to lose any width by folding and tacking to the base.

The base for me I think will be 3/4 TnG OSB, 1/2 foam interlocking squares, and TFD

Just looking for ideas

[bongta029]

What have you guys used for edging around your indoor putting greens?

I've seen some pictures of ones with no edging and the turf folded under the substrate. Im12 feet wide and that is exactly the width of the roll from TFD. I don't want to lose any width by folding and tacking to the base.

The base for me I think will be 3/4 TnG OSB, 1/2 foam interlocking squares, and TFD

Just looking for ideas

The edges actually have 2 inches wide black nylon stuff. You can fold that part underneath the subfloor amd you will not lose any part pf putting surface.

[abenjami]

What about using baseboard or quarter round?

[Parsaver]

What I think I'm going to do is get a 1*2 and round the end and cut a 1.5 in channel so it will hook over like an upside down J and then pin nale it to the OSB sub