Tweet
Anyone else have issues with the Skytrak and the holy grail hitting strip? I previously used a fiber built strip and never had many issues with misreads or no reads once I got everything properly set up (level with unit etc).
I've done the same leveling etc with the holy grail but get quite a few no reads or mis reads where the ball goes completely offline at start.
I think part of the issue may be the long sides of the mat have no foam underneath causing the edges to be slightly higher than the middle of the mat. The foam on the long sides don't start until about 2 inches. Measuring from middle of two long sides I get about 1.75 inches of height off the ground while measuring from middle of short sides is about 1.5 inches off the ground.
I've done the same leveling etc with the holy grail but get quite a few no reads or mis reads where the ball goes completely offline at start.
I think part of the issue may be the long sides of the mat have no foam underneath causing the edges to be slightly higher than the middle of the mat. The foam on the long sides don't start until about 2 inches. Measuring from middle of two long sides I get about 1.75 inches of height off the ground while measuring from middle of short sides is about 1.5 inches off the ground.