Tweet
I recently purchased the HG to replace my fiberbuilt insert. Love the mat but they don’t have the pre drilled holes for the tee insert. I have the birties but hate having to chase them all over the room. Has anyone drilled a hole to the HG for tee insert? My only issue is where the hole needs to go to, the strip of cushion is right there..trying not to mess it up..I was told to use 5/8 bit. Any help appreciated..
- Golf Simulator Forum is the center point for discussion on golf simulator products, brands, manufacturers, launch monitors and everything else related to golf simulation.
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
Comment