I just tapped in the grey anchors provided with my MW632ST and when I screwed in the hardware provided it was loose. I made sure to give each screw a couple dozen revolutions in order to activate the anchor but the screws just slid right out with about 5-10 lbs of pressure. Any ideas or suggestions? I tried to pull the anchors out with a needle nose plier but they are secured up there very firmly.
- Golf Simulator Forum is the center point for discussion on golf simulator products, brands, manufacturers, launch monitors and everything else related to golf simulation.
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
Comment