Tweet
Hi all,
I have been running a BenQ MX819ST in my garage simulator for almost two years using this https://www.amazon.com/gp/product/B0...?ie=UTF8&psc=1 KVM Switch to connect it to my basement office computer with no issues. Fast forward to a week ago my house lost power for 14 hours. When I went to fire back up the simulator the projector switches between "Signal Detect" and "Signal Searching" until finally it says no signal. over the past few days I've done all the troubleshooting I could think of (different cables, verified KVM is working properly using other monitors, verified projector HDMI port works when directly plugged into source) and for the life of me seems like the issue is with the projector receiving/reading the signal out of the KVM switch.
Has anyone else ran into this issue randomly popping up and if so have you found a fix?
Thanks!
I have been running a BenQ MX819ST in my garage simulator for almost two years using this https://www.amazon.com/gp/product/B0...?ie=UTF8&psc=1 KVM Switch to connect it to my basement office computer with no issues. Fast forward to a week ago my house lost power for 14 hours. When I went to fire back up the simulator the projector switches between "Signal Detect" and "Signal Searching" until finally it says no signal. over the past few days I've done all the troubleshooting I could think of (different cables, verified KVM is working properly using other monitors, verified projector HDMI port works when directly plugged into source) and for the life of me seems like the issue is with the projector receiving/reading the signal out of the KVM switch.
Has anyone else ran into this issue randomly popping up and if so have you found a fix?
Thanks!