Tweet
Here is what I have:
-ProTee Panel - I've added a thin piece of IR passing plexiglass over the sensor board. I did this for two reasons. First to protect the board and sensors and the second to eliminate stray ambient light which can cast shadow and effect readings. I've been very pleased with this modification. This makes it very easy to see dust and dirt accumulating but is very easy to wipe off with a paper towel or canned air. I think this is better than building up on the sensors though. I never liked the idea of exposed sensor on the ProTee. This can easily be removed by unscrewing the panels if desired.
-Putting Sensor
-Extra FiberBuilt Panel for follow through
-Two AR111 Fixtures with integrated transformer - Goes in H Track - These fixtures are expensive but allow you to use the AR111 bulb which provide much better light than any PAR I tried and I tried a lot of them. I'm also including extra AR111 bulbs which have an 8* spot and 75W - probably too much light for most setups but I won't need them
-2 IR pass filters - not really needed but can filter out ambient light and slightly darken image area if needed
-2 Active USB Extensions, 1 Passive USB Extension
-H and V Cam ( Enclosure for V Cam ) These have the upgraded lenses that Zmax recommends
-Add on USB Card
-Extra Tees for Fibrebuilt Panels
-ProTee Original Lenses, Power Supply outlet supplies
All you really need is the ProTee 2.0 Software and you are good to go with a few options if needed. Let me know if you have any questions.
Picture shows everything.
Asking 2000 plus actual shipping
Let me know if you have any questions.
-ProTee Panel - I've added a thin piece of IR passing plexiglass over the sensor board. I did this for two reasons. First to protect the board and sensors and the second to eliminate stray ambient light which can cast shadow and effect readings. I've been very pleased with this modification. This makes it very easy to see dust and dirt accumulating but is very easy to wipe off with a paper towel or canned air. I think this is better than building up on the sensors though. I never liked the idea of exposed sensor on the ProTee. This can easily be removed by unscrewing the panels if desired.
-Putting Sensor
-Extra FiberBuilt Panel for follow through
-Two AR111 Fixtures with integrated transformer - Goes in H Track - These fixtures are expensive but allow you to use the AR111 bulb which provide much better light than any PAR I tried and I tried a lot of them. I'm also including extra AR111 bulbs which have an 8* spot and 75W - probably too much light for most setups but I won't need them
-2 IR pass filters - not really needed but can filter out ambient light and slightly darken image area if needed
-2 Active USB Extensions, 1 Passive USB Extension
-H and V Cam ( Enclosure for V Cam ) These have the upgraded lenses that Zmax recommends
-Add on USB Card
-Extra Tees for Fibrebuilt Panels
-ProTee Original Lenses, Power Supply outlet supplies
All you really need is the ProTee 2.0 Software and you are good to go with a few options if needed. Let me know if you have any questions.
Picture shows everything.
Asking 2000 plus actual shipping
Let me know if you have any questions.
Comment