Tweet
I felt my gc2 distance was off, then other told me it's the "indoor" effect. So I took it out to the range just to make sure. The condition was about 85 degree and no wind.
with my best club the 7 iron was my starting pt. Ball scatter all around the 150 flag, a few in front but most of them were 5-10ft over. Gc2 was showing distance between low of 128yd high of 142yd. Then I tried the driver, it was landing around the 250 mark and roll. Gc2 reports between lowest 199 highest 238. Then my PW was landing right in front of the 120 flag every time. But GC2 range was 108-112. I also went to ask the proshop how accurate was the marks on the range. He said is very accurate, since the university men's team practices here.
so it seems my gc2 is off indoor and outdoor about 25 yds on the driver, 10-15yd off on the 7 iron and 10 yds off the PW. I have tried putting the gc2 1-2 inch above th ground. I tried with no protective case. I tried have it lower than the hitting surface. It all seems to give me lower numbers.
Is lighting or my hitting mat causing the issue? Or I assume I can't place the wrong to far or too close, since gc2 won't give me the green light unless is on the good spot.
and suggestions?
with my best club the 7 iron was my starting pt. Ball scatter all around the 150 flag, a few in front but most of them were 5-10ft over. Gc2 was showing distance between low of 128yd high of 142yd. Then I tried the driver, it was landing around the 250 mark and roll. Gc2 reports between lowest 199 highest 238. Then my PW was landing right in front of the 120 flag every time. But GC2 range was 108-112. I also went to ask the proshop how accurate was the marks on the range. He said is very accurate, since the university men's team practices here.
so it seems my gc2 is off indoor and outdoor about 25 yds on the driver, 10-15yd off on the 7 iron and 10 yds off the PW. I have tried putting the gc2 1-2 inch above th ground. I tried with no protective case. I tried have it lower than the hitting surface. It all seems to give me lower numbers.
Is lighting or my hitting mat causing the issue? Or I assume I can't place the wrong to far or too close, since gc2 won't give me the green light unless is on the good spot.
and suggestions?
Comment