Firmware update failed - now boot error

[abovethepin]

I was updating the firmware on a used gc2 I picked up, figured might as well get it all up to date (it was working perfectly before this, so I should have just left it alone...). Halfway through the update, it failed and is pretty bricked right. I attached an image of what I see when trying to turn it on now.

before paying the $500 transfer fee to foresight, and then whatever the repair costs end being, I figured I’d toss it out to this group.

If anyone has any ideas or experience troubleshooting these, it would be greatly appreciated.

Thanks in advance,
Brian

[mthunt]

I was updating the firmware on a used gc2 I picked up, figured might as well get it all up to date (it was working perfectly before this, so I should have just left it alone...). Halfway through the update, it failed and is pretty bricked right. I attached an image of what I see when trying to turn it on now.

before paying the $500 transfer fee to foresight, and then whatever the repair costs end being, I figured I’d toss it out to this group.

If anyone has any ideas or experience troubleshooting these, it would be greatly appreciated.

Thanks in advance,
Brian

You installed the firmware wrong or it didn't install properly. You bricked the GC2. Simply reinstall the firmware. If that fails try another firmware.

[abovethepin]

You installed the firmware wrong or it didn't install properly. You bricked the GC2. Simply reinstall the firmware. If that fails try another firmware.

Thank you. It took about 15 attempts to get the PC to connect to the GC2, but it finally did and I am back in business. Phew.