HELP - Foresight GC2 interface with TGC 2019

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • mattymo23
    Junior Member
    • Mar 2020
    • 2

    #1

    HELP - Foresight GC2 interface with TGC 2019

    All,

    I bought TGC 2019 in February for use with a skytrak. i have since upgraded my launch monitor to a foresight GC2. Does anyone know what i need to do to get the simulation software to work with the GC2?
  • gohandbz8
    Member
    • May 2020
    • 85

    #2
    Reach out to Protee for a license transfer. I believe it cost $100USD.
    Then following the instructions from this link to get it setup with the GC2

    Follow the steps below and in the next few post to initially connect your GC2 to GSX to ProTee Interface. Enjoy! 1: Connect your Bluetooth adapter to your pc's USB


    Get a usb extension cable long enough to put the the bluetooth module right next to the GC2. I bought the Asus USB-BT400 Bluetooth 4.0 per the recommendation on this forum.

    Comment

    • Wizard of Coz
      Champion Member
      • Nov 2018
      • 1201

      #3
      It's possible you might not need extension if using

      Comment


      • gohandbz8
        gohandbz8 commented
        Editing a comment
        Picked up the Asus BT500 and can confirm that you can use it without extension cable. My PC is about 5 feet away from the GC2 and I went through 2 full rounds without a dropped connection

      • Wizard of Coz
        Wizard of Coz commented
        Editing a comment
        That's 👍. I'm not the only one.
    Working...