Newbie - gc2 &tgc setup help

[Db85]

Hi all
recently swapped from a flightscope to gc2 so trying to configure and set up GC2 with protee/tgc.

win 10 laptop and internal Bluetooth

gc2 connects to laptop all ok (shows on win connection ok)

run gqsx2 and get this screen - won’t connect
assuming this is the fault?
reas through instructions but unable to locate where you can access the settings to set up comport and ip?

[Db85]

So I’ve just installed an older gsx which connects and pulls through to protee interface, however within tgc it isn’t picking anything up (but registered on gsx/interface)

[Db85]

[Db85]

I do get this in black text however? Any help greatly appreciated

[alexsmith11]

did you go through the GSX settings? Make sure TGC is selected under the TGC tab.
Also, have you set-up the Comm port etc? Steps 4,5,and 6 explain the comm port set-up in this thread https://golfsimulatorforum.com/forum...and-protee-2-0

[mthunt]

Hi all
recently swapped from a flightscope to gc2 so trying to configure and set up GC2 with protee/tgc.

win 10 laptop and internal Bluetooth

gc2 connects to laptop all ok (shows on win connection ok)

run gqsx2 and get this screen - won’t connect
assuming this is the fault?
reas through instructions but unable to locate where you can access the settings to set up comport and ip?

First, GQSX2 is for a quad, not a GC2. Did you switch to the ProTee version of TGC2019 or are you using the FS Version?

[Db85]

First, GQSX2 is for a quad, not a GC2. Did you switch to the ProTee version of TGC2019 or are you using the FS Version?

Ah didn’t realise about gqsx2 - it’s just what I was sent but quickly realised it wasn’t quite right


as For your second point about tgc, you were bang on, I checked this earlier and realised it was still showing flightscope, so protee sent me a 2nd license code out which updated this and then fixed my issue I was having

tha l you guys for your help - working like a charm now
can now start getting my winter practice in now