Sim Room Space | Looking for feedback

[Mark_Winkler]

Attaching a rough drawing of the space that I'm looking to use for a sim room.

With the floor dropped (which I haven't done yet), it'll give ~9.5ft from floor to ceiling in the middle part of the wall, sloping down on the edges.

I realize it's not ideal to have the odd shaped wall for the screen but this is the best space I have available.

I've never done a simulator setup and I'm looking for feedback about issues I may run into, ideas on what to do about the windows, and any other comments anyone wants to offer.

Thanks!

[Tonysmjc]

Windows in that poi’s Orion could be trouble for an errant shot
shutters would solve it

Lots of good sims will work with those dimensions

ill only say I find different things have an effect on swinging inside based on how you feel about them

i find floor units and small rooms distracting and my room is small so I’m limited to irons and maybe a 5 hybrid
even after going to an overhead sim

my rooms big enough for a righty to swing away with driver but I have a hard time accepting it mentally so I don’t do it as it’s bad practice

you be different

over all I think the dimension should work as long as your comfortable with the space you have to swing any given club

[mikemcd22]

That Space should be very reasonable. How far is it from the screen to the windows? You will probably want to purchase some blackout material for them along with the shutters or protection of some sort mentioned by Tonysmjc . 16' Wide should give you enough room for lefties and righties if you can clear that slope with a driver. Otherwise you might have to offset a little. If you can get to 9'6' in the middle, it's calling out for a Uneekor IMO (if that's your preference).