Flush Mat

[GolfinToad]

I did the same thing this spring. I have a Fiberbuilt 1x4 mat and cut it the floor only 2 inches and chipped it out. Then I put in some leveler and place the mat into the cutout. I do have a standing mat but with the carpet and most people wearing tennis shoes no need to use the mat anymore. But I love it and should have done it sooner.

[Holtzeeeeee]

Shoot wish I had thought of that ... would have saved quite a bit of money! Well done!

[Holtzeeeeee]

GolfinToad ... pretty sure I saw your video of the gc2 slider. I’m looking to do something similar so I can putt off the fiberbuilt insert. I would have it go parallel with it vs perpendicular like yours but same concept. Can you share details? Looks awesome!

[GolfinToad]

Brian,

I do not have a slider. I have seen a few but do not have one.

[Carl Johnson]

Just a quick update - concrete company is coming tomorrow to cut the basement floor (approx. 4' x 9') to allow me to install the Fiberbuilt hitting mat into the floor. The basement is already fully finished so I had to remove the carpet then create a 'clean' room so they do not make a mess when they wet-saw the concrete. What a pain - wish my basement was not finished yet!!!!

[Holtzeeeeee]

Did you consider only doing the hitting strip like others have said?

[Carl Johnson]

The cost was going to be the nearly same for nearly any size hole since it is the set-up, etc. which was most of the cost. They did not care if it was 1x4 or 4x9 - price was nearly the same. By cutting out the entire 4x9 area - allows me the flexibility of changing mats, adding a pressure mat later on, etc.

[Carl Johnson]

Here is a picture of the entire area removed! Concrete was much thicker than they anticipated, along with fiber mesh! Typical floor is about 3-4" thick - mine is closer to 5" thick! Time to fill in the hole with more stone dust then padding under the FB mat!!

[Carl Johnson]

Here are some more pictures with nearly the finished product! Just need to add some trim around the carpet - where it 'meets' up against the FB mat. And re-glue the 2x carpet seams. It has been a lot of work ... just to gain 2+ inches of swing height!!

[What4]

just an FYI - if you live in a high radon area like i do, setup a radon monitor if cutting through your basement floor.

[Carl Johnson]

What4 - I totally agree. I have a sub-floor radon system which pulls the air underneath the entire concrete floor of the basement, then it goes up a pipe into the attic then out the roof via a radon fan/motor. By adding several inches of stone dust at the bottom of the mat 'hole' - that should have sealed the air under/around the area I cut out. In turn preventing the radon motor from pulling air from the mat hole, which is basically the basement air!