I purchased a martin hall 5 star urethane backed golf mat for my simulator room. They had a 5’ x 10’ mat for $511 with free shipping specifically for golf simulator rooms. The long width of 10 feet gives me a lot of room for both righties and lefties The mat is 1-1/4 inch thick which is the same thickness as the divot action strip. I am planning on cutting in a 12inch by 24 inch divot action strip and I was wondering what the best way to cut in this strip would be. As mentioned earlier the mat is not foam backed it is urethane back. Should I cut from the back? I want it to look professional and want the strip to be tight in the opening. Any suggestions? I’m sure many of you have done this?
- Golf Simulator Forum is the center point for discussion on golf simulator products, brands, manufacturers, launch monitors and everything else related to golf simulation.
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
Comment