Construction Begins on Sim Room Addition

[Kaos]

Is the size of the projection adjustable. It doesn't seem to fit the screen. Forgive if this is a newb question.

As it turns out, the enclosure needs to be reassembled. This was their older version and the instructions did not tell you that the bars should only go in 4 inches. We pushed them all the way in. So, I am ~6" too short and ~4" to little width. SIG said that it was their fault as the instructions did not specify. I will post a pic with the enclosure reassembled and illustrate how much tighter the screen is. SIG said the new version (same dimensions) will only go together one way. I may end up moving or adjusting the projector afterwards to get a little larger image.

[Dax]

I was just going to comment on the build and say the room looks great, but that the screen looked like it needed to be a little bit tighter.

[Kaos]

Okay...I had to tear the enclosure down and rebuild thanks to SIG not telling me about the 4 inches! That and I had to adjust the projector. The whole project took me about 2.5 hours, but, man is the screen looking good now! I wasn't happy with it before, but it looks like is suppose to now.

[jasonreg]

Much better for sure! Time well spent!