4 of my infrared lights are out!

[Jaygord34]

So 4 of my lights are out in the front row of my unit. It still registers shots but I'm assuming it can't possibly be reading 100% with those lights out.

I opened up the unit to look at the control board and R125 is broken.

Is R125 a 1500 ohm resistor? Can I buy and kind of 1.5k resistor and solder in as a replacement?

I touched a jumper between the solder points of the R125 and 2 of the 4 lights that are out went on. Touch a jumper between R123 and remaining other 2 go on. Could I just solder a jumper wire on r125 & r123 and the unit work properly?

Link to pictures --> http://imgur.com/a/ftWlKwg

[Phillippi76]

I recently hunted down all the parts needed to fix the Optishot. The Emitters, Receivers, and resistors. The emitters are OSRAM SFH4556. The receivers are OSRAM SFH313FA-3/4. The resistors are SMD 1/4 watt 150 Ohm easily sourced from Amazon. When installing the emitters, the long pole faces the outside of the board on both sides. On the receivers, the long pole faces inside the board. I made a short video showing all this but don’t know how to post it. If someone would like, I can email it to you to post. Hope this helps.