Single length irons?? Anyone using them?

[Boerdoc]

Well I just played my first round with my new Cobra One Length irons. The round was not spectacular but solid for me. It is long as well and I needed to hit several 5 irons as approach shots. These were easier to hit than my previous ones. After a few rounds I hope to be more consistent with my ball striking. Time will tell if they are just a gimmick or a real benefit for me. The distances were ok as well. Too early to tell about gapping. after a few rounds I should have that down.
One rewind on a 0.5 inch chip shot.

[Joko]

I've been getting more and more interested in these. Looking forward to hearing your progress. I'm hoping my next set is a single length set. Wishing you luck.

[Boerdoc]

I am left-handed and the only ones available are the King F7 non-forged. They use different head designs so that the head weight and swing weight are the same throughout the set just like the lengths being equal. So swinging a 5 irons feels the same as a GW. It is a little weird in the beginning but I just played them at the same distances as my Mizuno JPX-EZ forged irons. You just need to trust that your GW being longer will not go flying past the hole and trust that your "short" 5 iron will go 185 like it did in your previous set. Only one round played with about 5 swings of each club beforehand. So far so good. I am trying so simplify things. I still have 54* and 58* Mizuno t7 wedges. They do make a 55* sand wedge as well but I did not get it.......yet!





3i-5i FULL HOLLOW


6i-7i HALF HOLLOW


8i-PW CAVITY BACK


GW-SW SPECIALTY

4*	20°	62.5°	5.5	37.25"	37.25"	D0	D1	RH/LH
5	23°	62.5°	5.1	37.25"	37.25"	D0	D1	RH/LH
6	26°	62.5°	4.6	37.25"	37.25"	D0	D1	RH/LH
7	30°	62.5°	4.1	37.25"	37.25"	D0	D1	RH/LH
8	35°	62.5°	3.8	37.25"	37.25"	D0	D1	RH/LH
9	40°	62.5°	3.6	37.25"	37.25"	D0	D1	RH/LH
PW	45°	62.5°	3.2	37.25"	37.25"	D0	D1	RH/LH
GW	50°	62.5°	1.0	37.25"	37.25"	D0	D1	RH/LH
SW	55°	62.5°	0.7	37.25"	37.25"	D0	D1	RH/LH