Chicago Open at Village of Glenn Ellyn 2/2-2/9

[Craig118]

Anyone available for second round Saturday after 2pm?

[theLONO]

I can play then theLono, unless someone else that needs to get rounds in can play.

I'll meet you in team speak.

[Bubba22]

K

[Bubba22]

Good round theLONO. That was fun playing with you. If not some of those close putts that robbed you, you would have shot lower.

[theLONO]

Good round theLONO. That was fun playing with you. If not some of those close putts that robbed you, you would have shot lower.

Good times indeed. Loved our pace of play. Non stop action! Thanks for the game.

[theLONO]

Anyone available for second round Saturday after 2pm?

Can you do Sunday Craig?

[Maverick]

Round 1



Round 2

[Libbing]

Craig & Lono - I need to get two rounds in this weekend - I can play any time Saturday or Sunday.

Might be painful. Pulled a bonehead move while swapping out my tee and busted the connector on the flat ribbon come from the putting sensor. So need to putt with my driver off the tee until I can swap out the connector. Just can't keep my head off the sensor with my putter. Ugh. Might be doing some chipping on the greens!

[bubs3141]

Mike

you should be able to fix it, I broke mine in the past. Just put the ribbon back in the connector and make sure the holes line up with the prongs.

[Maverick]

Ouch! My putting sensor had a bad connector when I got it. I had to replace the 25 pin connector. It was a P.I.T.A....

[theLONO]

Craig & Lono - I need to get two rounds in this weekend - I can play any time Saturday or Sunday.

Might be painful. Pulled a bonehead move while swapping out my tee and busted the connector on the flat ribbon come from the putting sensor. So need to putt with my driver off the tee until I can swap out the connector. Just can't keep my head off the sensor with my putter. Ugh. Might be doing some chipping on the greens!

Perhaps you play with Craig on Saturday for your first round and me on Sunday for our second rounds. Looking forward to seeing driver putts. .

[Craig118]

I can play this afternoon Mike, just need to let it warm up a bit. Its like 4 degrees this morning and takes too much to heat my garage at that temp. How about 1 or 2ish when it "warms" to the 20's?

I pulled the same stupid move with my putting sensor connector. My set up being temporary I always have to unplug it from my stance mat when finished. I was in a rush a couple weeks ago and forgot to unplug it..... lifted up my stance mat and the coupler went flying. I thought I ripped the ribbon cable right in half at first. Thankfully the coupler has a break away design and the pins lined right back up. What a sigh of relief when I confirmed all my putting sensors were still functioning. I have since counter measured by adding an 2' extension serial cable and an cable anchor on my stance mat.

[Libbing]

2:00 (eastern time I assume) sounds good. No rush for me.

I should have known better on that connector. I hadn't left enough room in the subfloor for the plug, so it was always a bit of a struggle to get it back in when I lifted the sensor out. Only took 5 minutes to cut a notch out of the wood to give it room. That 5 minutes would have been better spent before I broke it!

Lono - Open anytime on Sunday (probably after 9:00 Eastern so I don't wake anyone up)

[Craig118]

OK Mike, see you at 2 pm EST.

[Libbing]

Lono - would 10 or 11am Eastern on Sunday work for you?