Protee sensor

[Stonebattle]

Is there a document that describes how the protee sensor functions? I am trying to improve misreads on the unit I have. The setup is good. All of the internal sensors are working and they are clean. So, I wondering just is this sensor suppose to work.

[Bubba22]

Try this Stone https://csc.protee-united.com/hc/en-...ng-the-sensors

[Stonebattle]

Thanks Bubba
I have gone through the page you recommended line by line in order to make sure my sensor was working correctly. I could not find an issue, but will do the trouble shooting again to make sure.

I want to read more of a theory of operation. The reason is, I have been getting more than my share of misreads. Normally way right. I made some adjustments to the club face in the Alt E file, but it seems I made the situation worse. So, I thought I would take some data in order to get a better idea how much and what direction I should adjust the club path and face in the ALT E to get improved results.

I thought I would hit some wedge pitches, alternating between a 10 degree pull and push and then toe strikes and heal strikes. I wanted to see what the sensor was reading so I could make reasoned adjustments. Now that I have the data, I'm more confused than I was before. The front ball sensor seem to be picking up ball direction well enough, but that direction has little to do with the measure face angle. I believe the face angle should be the major determining factor in ball direction. Also, the strike location seems off by quite a bit most times. The sensor gets the direction right, but the amount sure is off. It would seem the internal sensor locations are close enough to make a better approximation. It also seems to me when the front ball sensor misreads the ball direction, the default is way right. I do not have data on that, just observations as of now.

	Attempted	Measured	Measured			Simulated Results
	Degrees	Face	Degrees		Face	Degrees	Degrees	Degrees	Degrees
Push	Ball Path	Ball Strike mm	Ball Path		Ball Strike mm	Club Path	Ball Path	Face	Face to path
1	10	19	9		4	10	12	5	-5
2	-10	25	-9		4	-6	-10	-4	2
3	10	12	11		2	11	14	5	-6
4	-10	20	-10		4	-4	-10	-2	2
Pull
1	10	-5	9		-2	11	8	5	-6
2	-10	-5	-11		-4	-5	-10	-5	0
3	10	-7	7		-5	10	7	5	-5
4	-10	-10	-8		-5	-5	-7	-5	0
		Ball strike + towards toe - towards heal

[Stonebattle]

Whoops, I think the last face to path data point is wrong, it should be 8 degrees.

[Stonebattle]

Bubba:
Interesting you put me onto that page. I must have done the tests shown on the page at least 5 times before. I did the tests again and at the start I did not see any issues. After I did it several times, one of the sensors in the exit row stayed on. Protee helped me sort out the issue and get to an authorized repair facility. I hope this works out.