I've seen people comment about this before in other threads but I can't seem to find them anymore. Sometimes when I go into the vcam settings in protee interface, the floor is shifted almost to the top of the preview window and I have to click the Preview button to reset it back to normal. This happens quite often and I'm not exactly sure what causes it. I know going to hcam, selecting a club and clicking preview there, then going back to vcam is usually a good way to reproduce the glitch. The hcam has never done anything like this. Is there a way to stop this from happening?
- Golf Simulator Forum is the center point for discussion on golf simulator products, brands, manufacturers, launch monitors and everything else related to golf simulation.
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
Comment