Help adjusting driver settings

[EVLJWW]

Driver does not act normal. I am a senior PGA club pro and people always comment I never miss a fairway. Well on pro tee I never hit a fairway so I wonder if something is set wrong. Reading show 1 or 2 degrees in to out path consistently and face angle only is anywhere between 2 open and 2 closed. I think it’s very good in my mind. But the ball is either a big slice right ou pull hook. Distance for me is probably a bit short and for my brother in law driver is very short. I see people talk about adjusting driver 2 and other clubs some other numbers. We have the new cameras and updated software out after mid October. I can’t find where these adjustments are made. Does the new software not have the same way of adjusting? If it does where and how do I do it.

Also so one other issue. A friend has a white head driver. He gets very bad readings. Ball goes dead left very often.

[aeroburner]

cameras are picking up clubs on the white heads i actually had to spray paint my aeroburners back in the day for readings to pick up correctly

[gene438]

A couple of things to look at.

1) make sure none of your sensor lights are covered with turf debris or anything. You can visually inspect and blow off and then look at debug settings and it will indicate if any sensors are covered. If you have shots that take off immediately left or right even though you hit the ball in the middle of the screen....then this is probably it.

2)Aeroburner is right in above statement. Look at your vcam...do you see the ball streak then a half circle streak (your club head)....if the red line is going to that then that is your problem.

3)If you are in/out less and club face are both less than 1 or 2 degrees then you should not be seeing huge variations unless the ball is jumping left or right off the tee because of sensor failure or debris..

just some thoughts

[Libbing]

I've noticed the default protee setting seem to be a bit overly harsh not the swing path / face position ratio compared to real life. A 2 degree in-to-out with a 2 degree open face will show a big slice. And a 1 degree in to out with a 2 degree club face shows a really big draw or even a pull draw. There are settings to change the sensitivity (I think there is a club path to face ratio and I think the forgiveness setting might impact this as well, but not completely sure). I haven't played around with these enough to suggest how to change them, but they are there.

The settings for these advanced features are accessed by hitting alt-e when the settings screen for the interface is open. It opens up a text file that you can change. There is a group of setting that are controlled by the interface (so don't change those) and then an advanced set you have to use this alt-e function to change.

[Libbing]

You might be able to change your camera settings enough for the white driver head to work. I had a guy over using a Tailor-made M2 driver with the white strip and it worked. A complete white head might be too much.