Tweet
Hey everyone.
I am having issues getting my Skytrak to work in network mode. It connected the first time I tried to set it up and then lost the connection and can't seem to get it back. I was able to get the device registered prior to losing the connection.
I can now get to the point in network mode where the top light is red, middle light is yellow, bottom light is green (all solid) after the unit sits like this for a min or so it goes to top and middle lights red.
I have tried following the support I see on their site and on here and am somewhat at a loss.
I have shortened my ssid to have less that 11 characters and no special characters (funny enough the first time it connected the ssid had special characters), I am on 2.4 with both the Skytrak and iPad. and tried using both a year old iPad and an iPad pro. I am also in the same room with my router trying to get it set up so signal strength shouldn't be an issue. I am able to connect in direct mode. I also drove the unit down the street to reset it.
I did get the unit working in direct mode, but the delay from hitting to seeing a reading is around 30 seconds, is that normal?
Really appreciate any help or resources.
I am having issues getting my Skytrak to work in network mode. It connected the first time I tried to set it up and then lost the connection and can't seem to get it back. I was able to get the device registered prior to losing the connection.
I can now get to the point in network mode where the top light is red, middle light is yellow, bottom light is green (all solid) after the unit sits like this for a min or so it goes to top and middle lights red.
I have tried following the support I see on their site and on here and am somewhat at a loss.
I have shortened my ssid to have less that 11 characters and no special characters (funny enough the first time it connected the ssid had special characters), I am on 2.4 with both the Skytrak and iPad. and tried using both a year old iPad and an iPad pro. I am also in the same room with my router trying to get it set up so signal strength shouldn't be an issue. I am able to connect in direct mode. I also drove the unit down the street to reset it.
I did get the unit working in direct mode, but the delay from hitting to seeing a reading is around 30 seconds, is that normal?
Really appreciate any help or resources.
Comment