Need help getting PS3 Eyecams to work

[gene438]

OK guys, I bought two PS# Eyecams to try and put together a video swing system. I downloaded both the single and multiple camera driver/sdk from Code Laboratories. My problem is that I can only get 1 camera to be picked up. I can swap them, I can get a single camera from any usb port....but, I cannot get the 2 cameras to show up at the same time. I cannot get this in the Eyetest that comes with Code Laboratories sdk and I cannot get them to show up in Kinovea.

Please help....

[inorkuo]

plug in one camera only. fire up kinovea and bring the one camera up. then plug in the 2nd camera and bring it up in kinovea. it also seemed to matter which camera was plugged in first. it works. it's just a pain in the butt.

[gene438]

OK, i got the two cameras working doing what you said. Now I want to confirm if I understand correctly. I have 2 capture screens, so if I want to record, I actually make 2 capture videos, right? I have to push record on both sides, correct? Or am I missing something that would allow me to just record both videos in one file??Is that possible?

[gene438]

Hey Inorkuo, I read your thread....did you end up using audio zone or tonenet? Also, I tried downloading your exe file but it says it is "invalid", can you post it again?

[inorkuo]

i use audio zone trigger bc i had already purchased it before faulty posted about tonedet. either one should work though. the exe is in the zip. the au3 files are in there too if you want to mess with the code.

[gene438]

Can't download your file...it gives me a message "invalid file"

[inorkuo]

Maybe bc the zip has an exe in it, your antivirus is blocking it. I've renamed it to "dot exe". After you download it rename it back to ".exe"

[gene438]

must be something with forum software....I tried on my mac and PC....invalid file specified....

[inorkuo]

send me your email address

[wbond]

zip file downloaded just fine from the link above.