Impact Screen Frame Dimensions

[700kid]

I am looking to build a DIY enclosure loosely based off the "Gung-Ho" DIY. I have ordered a impact screen from Carls. It is 12'x8' and has finished edges with grommets. I will be finishing with carpet runner and pipe insulation. My question is what dimensions do I make the enclosure to make sure it has the right tensions for the screen? Assuming it will need to be oversized obviously I have the 6" ball bungees to secure the screen

[pDubs]

It doesn't look like Carls has cut specs for 12x8 yet, but they do have 12x9 and 8x10. So you could just take the measurements from each of those.

https://www.carlofet.com/wp-content/...eet-9x12x5.pdf

https://www.carlofet.com/wp-content/...t-8x10-5x5.pdf

You would cut 6 1" EMT pipes to 68 7/8", then the vertical pipes (4 of them) would be 95 1/4".
The fittings add a little length so it would be 8.33 inches tall, by 12.2 inches wide, perfect to bungee the screen on.

[GrecoISU]

I just ordered a 150x110 screen 12'6'' x 9'2''. I'm building a 12x9 frame and I'll leave about 4-5 inches on top and both sides and fold with tarp clips the rest of the screen on the sides. I wish I could go wider but it's not in the cards.