I've created a stand for the FlightScope Mevo+ Launch Monitor. There are times where I use the Mevo+ in my simulator room and then take it out to the driving range and then back to my simulator so I wanted something that can easily be adjusted because not every floor is perfectly level. Also some apps are 12°, 16° and 17° so this allows you to not only adjust the Tilt Axis (front to back), but also the Roll Axis (side to side). When you take the Mevo+ off the stand, you can easily set it back on the stand and have the same tilt and roll as before with no adjusting.
- 3D Printed (no metal interference)
- Adjustable Tilt (+- 16°)
- Adjustable Roll (+- 3°)
- Nylon locking nuts for consistent tight fit
- 8mm flat from floor to 30mm ( 5/16 in. to 1 1/4 inch )
selling them for $80 with shipping or if you have a 3D printer you can print this and pick up the parts yourself...This is a cheaper option instead of the metal casing that is available for $200...I'm trying to get a feel for people that would be interested in this since I have to make them 1 at a time
PM me
- 3D Printed (no metal interference)
- Adjustable Tilt (+- 16°)
- Adjustable Roll (+- 3°)
- Nylon locking nuts for consistent tight fit
- 8mm flat from floor to 30mm ( 5/16 in. to 1 1/4 inch )
selling them for $80 with shipping or if you have a 3D printer you can print this and pick up the parts yourself...This is a cheaper option instead of the metal casing that is available for $200...I'm trying to get a feel for people that would be interested in this since I have to make them 1 at a time
PM me
Comment