Chicago Open at Village of Glenn Ellyn 2/2-2/9

[theLONO]

Lono - would 10 or 11am Eastern on Sunday work for you?

I like 10amEST Mike

[Libbing]

Great, see you at 10

[Maverick]

Nice round thelono. Looks like you 2nd place locked up.

Mike libbing, must be tough putting with a driver. Ouch!

[theLONO]

Thanks. I was trying to put a charge on Bubs but he posted a hell of a number.

Congrats on the win Bubs!!

[bubs3141]

thanks

[Maverick]

Congrats Bubs.

2nd = theLono
3rd = Tom J

[Libbing]

Lono had a great round. Really split the uprights on some tight drives.

I wish I could blame all my problems on the putter. Probably lost 3 strokes / round with that. The rest was just simple erratic swinging. Couldn't repeat the same swing twice in a row.

Zmax - for handicapping, shave 3 strokes off each of those rounds. Will hopefully have that fixed for next weekend

[Maverick]

Will do.

[Bubba22]

Good playing guys. Congrats Bubs.

[bcgc0918]

Congrats Bubs.

[bubs3141]

thanks everybody.

[Libbing]

Ouch! My putting sensor had a bad connector when I got it. I had to replace the 25 pin connector. It was a P.I.T.A....

Z - just got my replacement connector finally. Of course the pins don't line up. Ugh. The two strips are farther apart than the existing two strips. Tried to see if just one row would work. Just pushed by hand Only about 1/3 of the sensors connect (the others show as triggered.

When you replaced yours did it line up exactly? Just wondering if I need to get one of the crimping tools and create new holes. Never done one of these and am wondering how hard that is going to be to get exactly lined up ()or if it is going to be all that picky as long as it punctures through)

[Maverick]

Hope you bought 2 or 3 extras. If my memory is correct, its a 25 pin connector but you only need 24. The 25th wire is an extra ground. Don't crimp on the same holes. Cut it back and then crimp. You can use big pliers but be careful not to damage the connector.