Problem with 3 wood.

[Cklguy2013]

I'm looking for some help on solving my 3 wood readings. On the h-cam I'm seeing a straight ball, but I might see a 6 degree closed clubface on the display which I know isn't correct. I've tried correcting in the interface but to no avail. Any thought??

Also in the interface does changing clubface from 0 to say 5, make it read more closed?

[aja]

Where does the ball come off the club face - What does the analysis screen show?

If you are not hitting it "dead center" the club will always have a tendency to twist. HCam may show a "straight" ball but the software will calculate a different trajectory based on the off-center hit (if that is the case).

The ProTee sensor is very accurate, especially with respect to clubface angle. I struggle with off center hits and the ProTee doesn't miss any of them.

[Cklguy2013]

Yes I did think of that, but it even does it with dead center hits, and I used foot spray on the face of the club to make sure it was reading a center hit probably, which it is. Oddly only have this problem with my fairway wood.