This is where I got to after last couple days.I hung a string from the ceiling with a small weight on the end (the rubber tee that came with fiberbuilt). Then used that to try and center everything up with alignment sticks and the alignment mode. I think I got pretty close. I threw some carpet squares down to help the bounce of the balls off the net rolling behind me. I velcroed the wood board down to the concrete, then duct taped the metal case legs to the board. Velcroeing the mat down is a good idea too that I will do when I get home. I think this will work for now and will protect against small bumps which was all I was trying to do. When I do alignment mode and throw a stick on the two dots it points basically right at the string so I think I am in a good spot. Hit a couple chips and irons right at the line and when I hit it it started out straight. The picture here is after a drive that nicked the line to the right. Basically started out straight and then faded left because of the spin. Thank you for everyone's help!
- Golf Simulator Forum is the center point for discussion on golf simulator products, brands, manufacturers, launch monitors and everything else related to golf simulation.
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
Comment