v2.3 Release - iOS and PC

[Godfather]

Cool. The USB connection works without issue now. Nice.

[bennyg211]

SkyTrak_Seth since v1.5 firmware my unit seems to be back to a heavy draw bias again as it was when I originally got the unit back October time. In fact the only thing that went right was when I shanked the ball. I did this at the range and could see the full ball flight and it was a calm day. I think I had the roll at 0deg and tilt may have been 0 to -1deg.
I hit a number of pushes and even push fades and all I saw on the unit were pull draws. The biggest block fade I hit in reality started maybe 5 yards right of target and faded to 20 yards right. The skytrak saw it as a pull draw that maybe started at 5 yards left a bad ended 15-20 yards left of target line.
I even tried to point the toe of the unit left to compensate, but all that did was keep the same shot shape but the ball ended up closer to target.
Distances didn't seem too bad, but shaot shape was wildly out for the fade/blocks. I hit a few draw shots and if I discount the pull effect on starting line, the shape was not bad, it's just finished 10-15 yards left of reality as it started as a pull in the software. I have just done a full reset of the unit plus iPhone and iPad and reset the wifi etc. Will test again down the range hopefully over the weekend.

[SkyTrak_Seth]

Be sure that you are using a clear marking on the ball, and new'ish golf balls. We didn't change anything regarding shot capture or image analysis with this firmware or software release. We haven't actually for a long time.

[Csarran]

My unit still gets the red light freeze and does not come back. Had to reset twice and still does it. This is in direct mode( The unit won't connect in network mode). Frustrating.

[dsailer]

I've had a problem switching from direct to network mode IF I do this when my network is present. It gets in a really bad state, so I only go direct mode at the range. For me, the fix is to try to get both the software and the unit back to square one - delete, re-install, reset - and then redo the original installation - if I can get the Skytrak app to show me the network connection parameter screen, I can get it fixed.

Is there a way to show the network connect parms in the Skytrak app on demand?

[SkyTrak_Seth]

Csarran , this sounds like maybe the unit is getting stuck on the firmware upgrade. If you have access to a PC and internet, I can do a remote assist with you and get you sorted. Please send me a PM if you are still having the issue.

[SkyTrak_Seth]

dsailer , if you r network is present and you choose network mode, then your unit should automatically connect to the network. If your network is not present, the unit reverts to direct mode and you should be able to configure a new network (like at the range). If you get 'in a bad state', resetting the unit via paperclip in the bottom will clear your network credentials from the unit. Just make a new post if we need to continue discussing so it doesn't get lost in these comments.

[golf4anh]

Since the release of 2.3, the between shots wait time had reduced tremendously. I'm able to hit shots after shots without waiting for the green light!


Sent from my iPhone using Tapatalk

[SkyTrak_Seth]

Huh? You can hit shots and have them register without the top light green or the laser on??

[Ironstrokes]

Since the release of 2.3, the between shots wait time had reduced tremendously. I'm able to hit shots after shots without waiting for the green light!


Sent from my iPhone using Tapatalk

Personally not feeling any difference yet, only have used it 2 or 3 times so far though, so we'll see if it becomes more apparent the more I use it